HP 9000 Superdome SX2000 HP Installation Guide, HP Integrity Superdome/sx2000 - Page 33

A 5-Wire Connector, WARNING, Installing the PDCA, Insert the PDCA into its slot

Get HP 9000 Superdome SX2000 PDF manuals and user guides View all HP 9000 Superdome SX2000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

Figure 27 A 5-Wire Connector To install the PDCA, follow these steps: WARNING! Make sure the circuit breaker on the PDCA is OFF. 1. Remove the rear PDCA bezel by removing the four retaining screws. 2. Run the power cord down through the appropriate opening in the floor tile. 3. Insert the PDCA into its slot (Figure 28 (page 33)). Figure 28 Installing the PDCA 4. Using a T-20 driver, attach the four screws that hold the PDCA in place. 5. If required, repeat step 2 through step 4 for the second PDCA. Setting Up the System 33

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
Figure 27 A 5-Wire Connector
To install the PDCA, follow these steps:
WARNING!
Make sure the circuit breaker on the PDCA is
OFF
.
1.
Remove the rear PDCA bezel by removing the four retaining screws.
2.
Run the power cord down through the appropriate opening in the floor tile.
3.
Insert the PDCA into its slot (
Figure 28 (page 33)
).
Figure 28 Installing the PDCA
4.
Using a T-20 driver, attach the four screws that hold the PDCA in place.
5.
If required, repeat step 2 through step 4 for the second PDCA.
Setting Up the System
33