HP BladeSystem bc2800 Service Reference Guide: HP BladeSystem PC Blade Enclosu - Page 30
Swapping the Interconnect Tray,
View all HP BladeSystem bc2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
14. Remove the midplane assembly from the enclosure (2). Figure 3-17 Removing the midplane assembly from the enclosure Reverse the previous steps to replace the midplane assembly. Swapping the Interconnect Tray To swap the existing interconnect tray with a replacement interconnect tray: 1. Remove the interconnect tray from the enclosure (Removing the Interconnect Tray on page 15). 2. Remove the Integrated Administrator module from the interconnect tray (Integrated Administrator Module on page 20). 3. Place the replacement interconnect tray on a level, non-conductive surface. 4. Position the Integrated Administrator module so that its holes are aligned with the anchor pins of the replacement interconnect tray (1). 5. Rotate the three anchor pins 90 degrees to lock the Integrated Administrator module into position (2). 6. Replace the two screw locks (3). 24 Chapter 3 Removal and Replacement Procedures