HP BladeSystem bc2800 Service Reference Guide: HP BladeSystem PC Blade Enclosu - Page 53
System Real Time Clock
View all HP BladeSystem bc2800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
POST Error Messages Code/Message 6911-System Board CPU Subsystem Failure Detected Health LED Red 6912-System Board Voltage Red Regulator Failure Detected 6913-System Board Main Red Voltage Failure Detected 6914-Forced System Green Shutdown from an over-temp fault condition on previous boot 6915-CPU not detected on previous attempt to boot. 6916-CPU Heatsink not properly attached Green Amber 6918-System Real Time Clock Oscillator not running within tolerance. Amber 6919-Temperature and Power Red Monitoring Hardware failure Possible Cause Recommended Action Processor has failed. ● ● Potential enclosure or ● blade PC issue. ● ● Potential enclosure or ● blade PC issue. ● ● Internal temperature ● exceeds specification. ● ● Clear CMOS. Replace the blade PC. Swap the blade PC to a different bay in the enclosure and retest. Put the blade PC into a different enclosure. If the blade PC works in a different enclosure, troubleshoot the original enclosure. For troubleshooting information, see Troubleshooting on page 49. Replace the blade. Swap the blade PC to a different bay in the enclosure and retest. Put the blade PC into a different enclosure. If the blade PC works in a different enclosure, troubleshoot the original enclosure. For troubleshooting information, see Troubleshooting on page 49. Replace the blade. Ensure that the system fans are functioning properly and that the enclosure has adequate ventilation. Check the processor heatsink. Replace the blade PC. The CPU was not detected on previous boot attempt. Informational message only. The heatsink is loose. ● Remove the blade PC and check if heatsink is loose or not present. Tighten CPU heatsink screws to 8 inch-lbs of tension. ● Replace the blade PC if the messages persist. System Real Time Clock Oscillator not running within tolerance. ● Replace CMOS battery. ● If the problem persists, replace the blade PC. Blade PC failure. Replace the blade PC. 47