HP ENVY 12-g000 Maintenance and Service Guide - Page 68
POGO pin (keyboard) connector cable, Disconnect the POGO pin connector cable from the system board
![]() |
View all HP ENVY 12-g000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
POGO pin (keyboard) connector cable Description POGO (keyboard) pin connector cable (includes Mylar screw/POGO cover, bottom thermal Mylar, side thermal Mylar, and thermal grease) Spare part number L14776-001 Before removing the POGO pin connector cable, follow these steps: 1. Shut down the tablet. If you are unsure whether the tablet is off or in Hibernation, turn the tablet on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the tablet. 3. Disconnect the power from the tablet by first unplugging the power cord from the AC outlet, and then unplugging the AC adapter from the tablet. 4. Remove the display panel assembly (see Display assembly on page 32). 5. Remove the Mylar shield (see Mylar shield (WWAN models only) on page 37). 6. Remove the battery (see Battery on page 40). Remove the POGO pin connector cable: 1. Disconnect the POGO pin connector cable from the system board (1). 2. Remove the two Phillips PM2.0×2.0 screws (2) that secure the POGO pin connector to the tablet. 3. Remove the POGO pin connector cable (3). 4. Remove the POGO pin connector cable. Reverse this procedure to install the POGO pin connector cable. 60 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
![](/manual_guide/products/hewlettpackard-envy-12g000-maintenance-service-guide-d4c3937/68.png)