HP ENVY 15-bp100 Maintenance and Service Guide - Page 46
SD card board cable, to which SD card board cable is connected, and then disconnect
View all HP ENVY 15-bp100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
SD card board cable NOTE: The SD card board spare part kit does not include the SD card board cable. The SD card board cable is available using spare part number 924325-001. Before removing the SD card board cable, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then unplugging the AC adapter from the computer. 4. Remove the bottom cover (see Bottom cover on page 30). 5. Remove the battery (see Battery on page 32). Remove the SD card board cable: 1. Release the ZIF connector (1) to which SD card board cable is connected, and then disconnect the SD card board cable from the system board. 2. Release the ZIF connector (2) to which SD card board cable is connected, and then disconnect the SD card board cable from the SD card board. 3. Detach the SD card board cable (3) from the keyboard/top cover. (The SD card board cable is attached to the keyboard/top cover with double-sided adhesive.) 4. Remove the SD card board cable. Reverse this procedure to install the SD card board cable. 38 Chapter 5 Removal and replacement procedures