HP Indigo WS6600 Splice Detection System Installation and Troubleshooting -- C - Page 15
On the other end of the sensor bracket, there are two pins and one screw hole. This end of
View all HP Indigo WS6600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
15. At the bridge front, remove the bottom M6 Allen screw from the leveling roller bracket. 16. Place the front holder bracket against the front wall and slide it to the left, until the leveling roller bracket. Do not connect it. 1 Notch 17. On the end of the sensor bracket where the cables are, there is one pin and one screw hole. This end of the bracket will be installed on the front holder bracket - the pin is placed onto a notch. On the other end of the sensor bracket, there are two pins and one screw hole. This end of the bracket will be installed on the rear holder bracket - the two pins are inserted into two pin holes. Installing the sensor 13
15.
At the bridge front, remove the bottom M6 Allen screw from the leveling roller bracket.
16.
Place the front holder bracket against the front wall and slide it to the left, until the leveling roller
bracket. Do not connect it.
1
Notch
17.
On the end of the sensor bracket where the cables are, there is one pin and one screw hole. This
end of the bracket will be installed on the front holder bracket — the pin is placed onto a notch.
On the other end of the sensor bracket, there are two pins and one screw hole. This end of the
bracket will be installed on the rear holder bracket — the two pins are inserted into two pin holes.
Installing the sensor
13