HP Indigo WS6600 Splice Detection System Installation and Troubleshooting -- C - Page 33

Systab It explains the systab references. ● SpliceEnable is marked TRUE for the feature to work as Skip and Continue. Value FALSE bypasses the feature completely. ● SpliceStopEnable is marked TRUE for the feature to stop the press if a splice is detected. Value FALSE bypasses the stop option, and only the default option of Skip is active. Table 3-2 Splice detection Systab Item or I/O Name Description Default engineConfigTopic > spliceDetectorHwType WHS presses, substrate splice detection hardware hostInfoOnlyTopic > spliceDetectorActive Splice detector hardware enable FALSE spliceDetectorParams > detectionEnabled Enable/disable splice detector UI configuration in Print Preferences TRUE spliceDetectorParams > forceManualSensorTeach spliceDetectorParams > itmNipToRWTableDistanceMm TRUE - start calibration process. For development only. Distance as substrate length, from ITM print nip till center of RW table 5300 spliceDetectorParams > lengthOfSpliceAreaMm Maximum possible splice area length, for one or two RL 146 skip calculation spliceDetectorParams > sensorTeachRequired Initiate sensor calibration at next print. Set after substrate replacement spliceDetectorParams > skipAndStopEnabled TRUE - skip and stop on RW FALSE - skip only spliceDetectorParams > spliceDetectionStatus 0 = splice detection disabled (by press) 1 = splice detection enabled (by press) 21 = first sensor calibration attempt 22 = second sensor calibration attempt 23 = third sensor calibration attempt 3 = sensor calibration successful, waiting for splice 4 = splice detected, splice on the way to ITM print nip 5 = splice skip active (advance of empty frame without engage) 6 = splice on the way to RW table 7 = splice stopped at RW table (only if Stop option enabled) 10 = Splice sensor calibration failed spliceDetectorParams > splicesCountPerBlanket spliceDetectorParams > splicesCountPerSubstrate Number of detected splices on substrate for current blanket zeroed with blanket replacement (by imaging) Number of detected splices on substrate for current substrate zeroed with substrate replacement (by imaging) Systab 31