HP LaserJet Pro 100 Service Manual - Page 62
CAUTION, Disconnect one FFC Callout 1
View all HP LaserJet Pro 100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
2. Remove five screws (callout 1), and then separate the sheet-metal plate (callout 2) and fuser power supply (callout 3) from the product. CAUTION: The sheet-metal plate and fuser power supply assembly is still attached to the product by a FFC connected to the engine controller assembly. Do not attempt to completely remove the assembly. Figure 1-49 Remove the ITB assembly (2 of 17) 1 2 3 3. Disconnect one FFC (Callout 1), and then remove the sheet-metal plate and fuser power supply assembly. Figure 1-50 Remove the ITB assembly (3 of 17) 1 44 Chapter 1 Removal and replacement ENWW
2.
Remove five screws (callout 1), and then separate the sheet-metal plate (callout 2) and fuser power
supply (callout 3) from the product.
CAUTION:
The sheet-metal plate and fuser power supply assembly is still attached to the
product by a FFC connected to the engine controller assembly. Do not attempt to completely
remove the assembly.
Figure 1-49
Remove the ITB assembly (2 of 17)
1
3
2
3.
Disconnect one FFC (Callout 1), and then remove the sheet-metal plate and fuser power supply
assembly.
Figure 1-50
Remove the ITB assembly (3 of 17)
1
44
Chapter 1
Removal and replacement
ENWW