HP Model 744 Installing the A4315A and A4316A HCRX/VME Graphics Options - Page 38
Power on your system and set the console device., Setting Y, our Graphics Configuration
View all HP Model 744 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Setting Your Graphics Configuration 1. Power on your system and set the console device. NOTICE: These instructions allow you to set the console device to any installed graphics device that has a monitor connected or to a terminal connected to the serial port. For the Model 743 SBC, the initial selection is not saved in stable storage. Complete all the steps given here to permanently set the console path. The Model 744 SBC saves the initial setting as the console device. a. Make sure that the monitor(s) are powered on. b. Hold the SBC's reset/abort switch in its Abt position, then turn on power to the VMEbus card cage. The following sections are separated into Model 744 instructions and Model 743 instructions. Please follow the instructions for your SBC model. 3-2