Home » HP Manuals » Desktops » HP Model 744 » Manual Viewer

HP Model 744 Installing the A4315A and A4316A HCRX/VME Graphics Options - Page 52

If you verify that you correctly installed and con d your graphics option and you, still

Add to My Manuals
Save this manual to your list of manuals

Page 52 highlights

Troubleshooting If you verify that you correctly installed and configured your graphics option and you still have no display, contact your designated service representative. 4-4

Section	Page
Installing the A4315A and A4316A HCRX/VME Graphics Options	1
Contents	3
Preface	5
Preparing for the Installation	11
Check That You Have the Necessary Equipment	12
System Prerequisites	13
Hardware Prerequisites	13
Firmware Prerequisites	13
Software Prerequisites	14
For HP-UX 9.x only, Configure X Windows and HP VUE	15
Setting Up a Single Monitor System (HP–UX 9.x only)	15
Installing the HCRX/VME Graphics Hardware	21
Remove SBC from the card cage.	22
Remove option boards and expansion board, if installed.	24
For Model 743 only, install new Boot ROM if required.	26
Install front panel extension plate, if needed.	27
Install HCRX/VME graphics board.	28
Install a blank cover.	30
Reinstall an option board.	31
Replace the SBC in the Card Cage.	33
Connect the monitor.	34
Proceed to Chapter 3, “Setting Your Graphics Configuration”.	35
Setting Your Graphics Configuration	37
Power on your system and set the console device.	38
Model 744	39
Model 743	41
Permanently set the console path and monitor type with the boot console handler.	43
Model 744:	43
Model 743:	44
For HP-UX 10.x only, Configure X Windows and HP CDE or HP– VUE.	47

Match case Limit results 1 per page

Troubleshooting

4–4

If you verify that you correctly installed and configured your graphics option and you

still have no display, contact your designated service representative.