HP Rp5700 Hardware Reference Guide - HP rp5700 - Page 36

CAUTION, Installing Guide Screws in the Optical Drive

Get HP Rp5700 - Point of Sale System PDF manuals and user guides
UPC - 884420470731
View all HP Rp5700 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 36 highlights

8. Pull out the lever on the left side of the drive (1) to release the drive, and then slide the drive forward out of the drive bay (2). Figure 2-25 Removing the Optical Drive NOTE: When replacing a drive, transfer the four guide screws from the old drive to the new one. To install an optical drive: 1. If necessary, remove the bezel blank covering the 5.25-inch drive bay. 2. Install two M3 metric guide screws in the lower holes on each side of the drive. HP has provided four extra M3 metric guide screws on the front of the chassis, under the front bezel. The M3 metric guide screws are black. CAUTION: Use only 5-mm long screws as guide screws. Longer screws can damage the internal components of the drive. NOTE: When replacing the drive, transfer the four M3 metric guide screws from the old drive to the new one. Figure 2-26 Installing Guide Screws in the Optical Drive 30 Chapter 2 Hardware Upgrades ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
8.
Pull out the lever on the left side of the drive (1) to release the drive, and then slide the drive forward
out of the drive bay (2).
Figure 2-25
Removing the Optical Drive
NOTE:
When replacing a drive, transfer the four guide screws from the old drive to the new one.
To install an optical drive:
1.
If necessary, remove the bezel blank covering the 5.25-inch drive bay.
2.
Install two M3 metric guide screws in the lower holes on each side of the drive. HP has provided
four extra M3 metric guide screws on the front of the chassis, under the front bezel. The M3 metric
guide screws are black.
CAUTION:
Use only 5-mm long screws as guide screws. Longer screws can damage the internal
components of the drive.
NOTE:
When replacing the drive, transfer the four M3 metric guide screws from the old drive to
the new one.
Figure 2-26
Installing Guide Screws in the Optical Drive
30
Chapter 2
Hardware Upgrades
ENWW