HP Rp5700 Hardware Reference Guide - HP rp5700 - Page 45
Installing Guide Screws in the Secondary Hard Drive, Installing the Secondary Hard Drive
UPC - 884420470731
View all HP Rp5700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
To install a secondary hard drive: 1. Install two 6-32 standard guide screws in the lower holes on each side of the drive. NOTE: When replacing the secondary hard drive, transfer the four screws from the old drive to the new one. You will need a Torx T-15 screwdriver to remove and re-install the guide screws. HP has provided four extra 6-32 standard guide screws on the front of the chassis, under the front bezel. The 6-32 standard guide screws are silver. Figure 2-41 Installing Guide Screws in the Secondary Hard Drive 2. Align the guide screws on the secondary hard drive with the slots in the chassis, and then lower the drive into the slots and slide the drive back until it locks in place. Figure 2-42 Installing the Secondary Hard Drive ENWW Installing and Removing Drives 39