HP StorageWorks 64 FW 07.00.00/HAFM SW 08.06.00 McDATA E/OS SNMP Support Manua - Page 137

active (4) loopback (5) txfault (6) noMedia (7) linkDown (8) connected to a device Port in ext loopback Transmitter fault media not installed waiting for activity (rx sync) McDATA SNMP Support 2 The Event Table The table of connectivity unit events. Errors, warnings, and information should be reported in this table. *fcConnUnitEventIndex Type Product Mapping Access Description Unsigned32 An event index. R Each connectivity unit has its own event buffer. As it wraps, it may write over previous events. This object is an index into the buffer. It is recommended that this table be read using 'getNext's to retrieve the initial table. The management application should read the event table at periodic intervals and then determine if any new entries were added by comparing the last known index value with the current highest index value. The management application should then update its copy of the event table. If the read interval is too long, it is possible that there may be events that may not be contained in the agent's internal event buffer. For example, an agent may read events 50-75. At the next read interval, fcConnUnitEventCurrID is 189. If the management app tries to read event index 76, and the agent's internal buffer is 100 entries max, event index 76 will no longer be available. The index value is an incrementing integer starting from one every time there is a table reset. On table reset, all contents are emptied and all indices are set to zero. When an event is added to the table, the event is assigned the next higher integer value than the last item entered into the table. If the index value reaches its maximum value, the next item entered will cause the index value to roll over and start at one again. Fibre Alliance MIB 2-119