HP StorageWorks 64 FW 07.00.00/HAFM SW 08.06.00 McDATA E/OS SNMP Support Manua - Page 399
ifSpeed, ifPhysAddress, ifAdminStatus, nominal bandwidth.
![]() |
View all HP StorageWorks 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 399 highlights
MIB II E Description Sequence The size of the largest datagram which can be sent/received on the interface, specified in octets. For interfaces that are used for transmitting network datagrams, this is the size of the largest network datagram that can be sent on the interface. ::= { ifEntry 4 } ifSpeed Syntax Access Status Description Sequence Gauge read-only mandatory An estimate of the interface's current bandwidth in bits per second. For interfaces which do not vary in bandwidth or for those where no accurate estimation can be made, this object should contain the nominal bandwidth. ::= { ifEntry 5 } ifPhysAddress Syntax Access Status Description Sequence PhysAddress read-only mandatory The interface's address at the protocol layer immediately `below' the network layer in the protocol stack. For interfaces which do not have such an address (e.g., a serial line), this object should contain an octet string of zero length. ::= { ifEntry 6 } ifAdminStatus Syntax Access Status INTEGER { up(1), -- ready to pass packets down(2), testing(3) -- in some test mode } read-write mandatory Groups in MIB II E-9
![](/manual_guide/products/hewlettpackard-316095b21-fw-070000hafm-sw-080600-mcdata-eos-snmp-support-manual-620000131620-2005-e90560b/399.png)