HP Surestore 64 fw 05.01.00 and sw 07.01.00 - Director Product Manager - User - Page 183
Table 7: Data Default Values, your director. For a list of values, refer to
![]() |
View all HP Surestore 64 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 183 highlights
Using Maintenance Features Note: If you have enabled features that add additional port function since the director was shipped from the factory, these features will be disabled (factory default) when the configuration is reset. Only those ports that were enabled at the factory will function. You will have to enable the additional port function features again through the Configure Feature Key dialog box. Factory-default values may vary, depending on the firmware release installed in your director. For a list of values, refer to the HP StorageWorks Director 2/64 Service Manual for the Director 2/64 and the HP StorageWorks Director 2/140 Service Manual for the Director 2/140. Table 7: Data Default Values Configuration Identification Description Director Name Director Description Director Contact Director Location Ports Director Addressing Port Names Port Blocked States Extended Distance (10-100km) LIN Alerts Port Address IP Address Subnet Mask Gateway Address MAC Address Default NULL string "Fibre Channel Director" "End User Contact (please configure)" "End User Contact (please configure)" NULL strings Unblocked Disabled Disabled Port number plus 4 10, mac[3], mac[4], mac[5] converted to word32 MAC addresses are set in hexadecimal; IP addresses in decimal. A MAC address of 08 00 88 20 00 57 will be reset to an IP address of 10.32.0.87. 255.0.0.0 0.0.0.0 PROM value Director Product Manager User Guide 183
![](/manual_guide/products/hewlettpackard-surestore-64-fw-050100-sw-070100-director-product-manager-user-guide-dda62f6/183.png)