HP XM600 hp kayak xm600 series 2, user's guide for minitower models - Page 45

Replacing the System Board

Get HP XM600 - Kayak - 128 MB RAM PDF manuals and user guides View all HP XM600 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 45 highlights

2 Installing and Replacing Hardware Parts in Your PC Workstation Replacing the System Board Replacing the System Board Removing the System Board 1 Switch off the display and PC Workstation. Disconnect all power cables and any LAN or telecommunications cables. 2 Remove the PC Workstation's cover (refer to page 24 for instructions). 3 To ease installation, place your PC Workstation on its side with the system board facing upwards. 4 Remove the PC chassis retaining bar. 5 Disconnect any cables attached to the system board. 6 Remove the main memory processor and any accessory cards from the old system board (described in this chapter) 7 Remove the four screws located near the processor sockets. 8 Remove the external screw located on the rear panel near the AGP PRO slot. 9 Remove the system board, being careful not to damage the PC's rear panel connectors. 10 Unclip the retaining bracket from under the system board. This bracket must be re-installed on the new system board. … ž ˆ  45

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
2
Installing and Replacing Hardware Parts in Your PC Workstation
Replacing the System Board
45
Replacing the System Board
Removing the System Board
1
Switch off the display and PC Workstation. Disconnect all power cables
and any LAN or telecommunications cables.
2
Remove the PC Workstation’s cover (refer to page 24 for instructions).
3
To ease installation, place your PC Workstation on its side with the
system board facing upwards.
4
Remove the PC chassis retaining bar.
5
Disconnect any cables attached to the system board.
6
Remove the main memory processor and any accessory cards from the
old system board (described in this chapter)
7
Remove the four screws located near the processor sockets.
8
Remove the external screw located on the rear panel near the AGP PRO
slot
.
9
Remove the system board, being careful not to damage the PC’s rear
panel connectors.
10
Unclip the retaining bracket from under the system board. This bracket
must be re-installed on the new system board.