HP XM600 hp kayak xm600 series 2, user's guide for minitower models - Page 48
Replacing the Fan and Speaker Assembly, Removing the Fan, and Speaker, Assembly
View all HP XM600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
2 Installing and Replacing Hardware Parts in Your PC Workstation Replacing the Fan and Speaker Assembly Removing the Fan and Speaker Assembly Replacing the Fan and Speaker Assembly 1 Switch off the display and PC Workstation. Disconnect all power cables and any LAN or telecommunications cables. 2 Remove the PC Workstation's cover and front upper and lower bezels. Refer to page 25 for these instructions. 3 Disconnect the cables from their connectors located on the system board. 4 For ease of installation, place the PC Workstation on its side with the system board facing upwards. 5 Remove the PC chassis retaining bar. 6 Remove the screw from the front of the chassis. 7 Unclip the three clips on the front of the chassis. 8 Slide the fan and speaker assembly towards the rear of the PC until it is clear of the chassis, then remove it from the PC Workstation. Replacing the Fan and Speaker Assembly 1 Place the fan and speaker assembly behind the internal shelves (the speaker should be near the bottom edge of the chassis and facing towards the front of the PC Workstation). Ensure all cables are clear of the assembly, then carefully move the fan and speaker assembly towards the front of the chassis. 2 Align the clips and guide pins with their appropriate sockets and slide the assembly forward to secure it into place. 3 Connect the fan and speaker cables to their connectors located on the system board. 4 Replace the screw on the front of the chassis. 5 Replace the retaining bar and secure it in place with the retaining screw. 6 Return the PC Workstation to its upright position. 7 Replace the front upper and lower bezels and PC Workstation's cover (refer to page 25). Reconnect all the power and telecommunications cables. 48