Hitachi IC25N040ATCS04-0 Specifications - Page 184
Individual Attribute Data Structure
UPC - 683728198664
View all Hitachi IC25N040ATCS04-0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 184 highlights
13.32.2.2 Individual Attribute Data Structure The following defines the 12 bytes that make up the information for each Attribute entry in the Device Attribute Data Structure. Description Attribute ID Number (01h to FFh) Status Flags Bit 0 Pre-Failure/Advisory Bit 1 On-line Collection Bit 2-5 Reserved (may be either 0 or 1) Bit 6-15 Reserved (all 0) Attribute Value (valid values from 01h to FEh) 00h invalid for attribute value -not to be used 01h minimum value 64h initial value for all attributes prior to any data collection FDh maximum value FEh value is not valid FFh invalid for attribute value-not to be used Reserved (may not be 0) Reserved (may not be 0) Reserved (00h) Total Bytes Byte 1 2 1 1 6 1 12 Offset 00h 01h Value binary bit flags 03h binary 04h binary 05h binary 0Bh binary Figure 124. Individual Attribute Data Structure Attribute ID Numbers: Any nonzero value in the Attribute ID Number indicates an active attribute. The device supports following Attribute ID Numbers. The names marked with (*) indicate that the corresponding Attribute Values can be either collected on-line or off-line. ID Attribute Name 0 Indicates that this entry in the data structure is not used 1 Raw Read Error Rate (*) 2 Throughput Performance (*) 3 Spin Up Time 4 Start/Stop Count 5 Reallocated Sector Count 7 Seek Error Rate 8 Seek Time Performance (*) 9 Power-On Hours Count 10 Spin Retry Count 12 Device Power Cycle Count 191 Gsense Error Rate 192 Power Off Retract Count 193 Load/Unload Cycle Count 194 Device Temperature Hitachi Travelstar 60GH & 40GN hard disk drive specifications 171