Honeywell VISTAKEY User Guide - Page 25

Performing Access Control Card Functions (cont'd) Press [*] to accept the entry. NOTES: • If you selected 00 "never invoke," the system advances to the "Block Entry" prompt. • For the ACS Event to occur, the card must be swiped at the access point defined in the following prompt. ↓ VISTA Card ID Number 001 Access Point? (01-15) 00 Enter 1 through 15 for the access point number corresponding to the event defined above. Press [*] to accept the entry. ↓ VISTA Card ID Number 001 ACTION? None 00 Enter two digits defining the action desired. For acceptable entries and their meanings see, Table 1: Action Codes. NOTES: • For the Action to occur, the ACS Event (defined above) must have been invoked by a card swipe at the access point defined in the above prompt. • Actions that arm or disarm a partition will only be performed if the VISTA User number (for the card) is assigned to the partition to be armed or disarmed. • Action codes 60 (AP Exit Only), 66 (AP Group Exit Only), or 72 (AP Partition Exit Only) disable the entry reader at the access point. The reader will remain disabled until a command is received (via a keypad command or event) to protect the access point. Press [*] to accept the entry. In response to the action entered, the system displays a message asking for additional - 25 -