Honeywell VISTAKEY User Guide - Page 8

User Commands (cont'd) Entry or Exit Entry Press 0 for entry or 1 for exit. The access point 0 is unlatched for the time period defined by your system installer. #75 The #75 command may be used to change the state (grant, bypass, or protect) of any access point. For the #75 command to be accepted, the following conditions must be exist. • If the partition is armed, Armed Restriction is in effect, and the user issues an access command, the user must be authorized to disarm the partition for the command to be accepted. • The user must have an assignment level of Master or Manager. • The user must be assigned to the access point's partition to protect or bypass the access point. • The VISTA user number must be assigned to the partition to which the keypad belongs. • The VISTA user number must be assigned to a card with an access group assignment that includes the point to which access is being requested. • The VISTA user number does not have to be assigned to the partition to which the access point belongs to be granted access, but if not they will be denied access while the partition is armed when an armed restriction has been programmed. Enter the #75 command as follows: User Code + # + 75 The following message is displayed on the keypad: Access Point 00-31 Enter two digits (from 01 through 15) that 01 correspond to the access point number where a change of state is desired. - 8 -