IBM 6 Operation Guide - Page 16

Erasing on Previous Lines 1. Press Paper Dawn to move the carrier to the line with the incor, rect character. 2. • Use Paper Up if you move Press Spaceber or Backspace back to() many to position the lines. printwheel pointer at • the incorrect character. If you are erasing several characters word, position the printwheel pointer in at a word,.or the entire the last Incorrect character In the word. Look at the example below: last incorrect Character The Central School Distrito laas Position Printwheel Pointer Here 3. Press the Correction key until each incorrect character in the word €s erased. Look at the example below. The Central School Distri has It the incorrect character is not erased, be surS the carrier is not above or below the typing line. 4. Type the correct characters as shown below. The Central School District has 5, Repeal steps 1 through 4 until all corrections havei been made. 6. Press Belem and continue typing. Practice Tthyepheigthheligfohlltoewd ienrgroprasr,agDroe'Pnohtlirneemboyvelintheeapsappreinrtferdombeyloowur. including type- , writer', The Central School Distrito has been granted funds, to establish a Demonstretion area; (Do not press Cabo Center to. serve this. entire Erase the incorrect characters using the following steps: 4 " 1. Press Paper Down two times to move the carrier to the line with the incorrect character (the second line). • it you move too far, press Paper Up. Remember, the paper moves one-half line each time you press Paper D0wn or Paper Up. - • Press the Spacebar to move the printwheel po€nter to e. • it you space too far, press Backspace. 3, Press the Correction key. 4. • The e is automatically erased. Type' a (the correct character). , • Press Paper Dowri two times, then press the the printwheel pointer to c (the last incorrect Spacebar character to in move the. Press the Correction key two limes.' • The t and c are automatically erased. Tpyrepses e correct characters), Retoo. 1 -GA rinArator's Guide Basic Operations 1-21