IBM 6 Operation Guide - Page 43

While Storing an Indented Job When storing an indented job (the Store light is on), you should set tabs for each temporary lett margin before you begin typing. • Pe sure to make all corrections in storage before setting or clearing a temporary left margin. • To correct errors when storing a job with indented lines, do not backspace beyond the temporary left margin to correct errors. Finish typing the job, then correct the errors during playback. To store an indented job: 1. Set tabs for each temporary left margin before you begin typing. 2. 3. Type until you reach the first indented line. Type any characters to the left of the temporary left margin (for example, a number or lette► when typing indented outlines). 4. Press the Tab key to move to the temporary left margin. 5. Hold down Code while you press Tab (Indent) to set the tempo- rary left margin. 6. 7, Type the indented lines. When you finish typing the indented lines, hold down Code while you press CRtn (InCir). While'RevIsIng Job • When revising complex jobs, be sure to play back and make revisions In the same pitch used to store the job. especially if job was stored In PS. •; Always open storage before making a revision. - The Store light must be on. • Always cloie storage after you finish revising the job by press Stor•. - The Store light goes off. • Pressing Store + the number (1 through 99) always opens storage at the beginn€ng of a Job. • If you play back too far or want to start over: 1. Press Play to stop playback. 2. Press Store + the number (1 through 99). 3. Press Play. (Playback starts again at the beginning of the job.) • Use the Correction key to erase unwanted carrier returns from stared Job: 1. Press Play or Play + Spacebar until the carrier return play back. 2. Press tie Correction key. • After mak€ng a revision, hold down Play while you press and release the Spacebar several times to make sore the next few characters play back correctly. • When revising indented jobs, be sure to stop playback at the wi or character you want to revise. Remember, you cannot use th Correction key to erase characters typed before you press Cod + Tab or Cede + CRth. Therefore, If you play back too far, yo may need to start playing back again from the beginning of the job. 3.24 Operator's Guide Storage 3.