IBM 6 Operation Guide - Page 80

Beeper Signals Each Time You Press a Key and the Star* Light Blinks Storage is full. Delete one or more storage areas pr press Store to close storage. If you proms Store, reposition the carrier to the last typing position and continue typing. See "Storage Full Warning" on page 3-27 for more Information. Beeper Signals Six Times and One or More Lights Blink 1. Make sure the printwheel is installed correctly. 2. Make sure the ribbon and correction tape cassettes are installed correctly. 3. Turn the typewriter off, watt 30 seconds, then turn the typewriter on again. If the same thing happens, install another printwheel. 4. Turn the typewriter off, wait 30 seconds, then turn the typewriter on again. If the same thing happens, call for service. • Tell your service person which lights are blinking when you place the call. All Lights Stay On Turn the typewriter oft, wait 30 seconds, then turn the typewriter on again. It all the lights still stay on, call for service. No Lights Come On 1. Make sure the typewriter cord is plugged into the back of the typewriter. 2. Turn the typewriter off, wait 30 seconds, then turn the typewriter on again. 3. Make sure the typewriter is plugged into a wall outlet. 4. Make sure the extension cord, It you are using one, Is plugged Into the typewriter cord. 5. Look to see if any other equipment plugged into the same wall outlet operates. 6. Make sure the wall outlet does not turn off with the room lights. eta el se • a ir • Erasing Problems ecilrsa ti e 6%.714 VW S. wirss C I S; Correction Does Not Erase All of the Character or Character Leaves Shadows 1. Make sure the ribbon and correction tape cassettes are fastened together correctly. • Make sure the center latch is latched securely. (See page 7-9 In the Reference section.) • Make sure the gray tabs are pressed In. (See pages 7-9 in the Reference section.) 2. Make sure the ribbon and correction tape cassettes are installed in the typewriter correctly. (See page 7-9 in the Reference section.) 3. Try plain bond paper. 4. Try a new correction tape. 5. Look for folds In the paper. 6. Make sure the typewriter Is on a level surface. r poi rcs i Mi t a dal 8-4 operator's Guide Problem Detarmlnatiork,,E41,,:ali