IBM 6 Operation Guide - Page 36

Removing A Word In a Stored Job Opening Storage 1. Insert paper. Install the same pitch printwheel and set the same margins, tabs, and line space you used when you stored the job. 2. Press Stare + the number where you stored the job. 3. Release the keys. • The carrier returns to the left margin. • The Store light blinks. • The ARtn light comes on. • Underlining is turned off. • The printwheel spins. 4. You may begin playback when the Store light comet; on solid. Playing Back 1. Press and release Play to begin playback, 2. Press and release Play or any key to stop playback,one or two words before the point where the word is to be removed. 3. Press and hold down Play while you press and release the Spacebar until the last character In the word and the space you want to remove prints on your paper. eF a 6GTra Gi hal 4, 3 itp o arm a Removing Word 1. Press the Correction key to erase the word and the space following the word from your paper. • The word is automat€cally being erased from storage and your paper at the same time. 2. Press Play + Spacebar to make sure the next character plays back correctly. Continuing Playback Press and release Play to print the rest of the job or to reach the next point to remove a word. Closing Storage Press and release Store. • The carrier returns to the left margin. • The store light goes off and storage is closed. The ARtn light stays on. • Underlining is turned off. • The printwheel spins. 3-10 Operator's Guide Storage 3-11