IBM 6 Operation Guide - Page 79

yary Problem Determination Index Beeper and Light Signals 6-3 Beeper Signals Three Times 6-3 Beeper Signals Three Times and Line Space Lights Blink Continuously 6-3 Beeper Signals Three Times and the Store Light Blinks 6-3 Beeper Signals Each Time You Press a Key and the Store Light Blinks Beeper Signals Six Times and One or More Lights Blink . All Lights Stay On No Lights Come On Erasing Problems 6-4 . 6-4 6-4 6-4 6-5 Correction Does Not Erase All of the Character or Character Leaves Shadows Typewriter Problems Typewriter Dead (No Lights Come On) 6-5 6-6 6-6 Typewriter Operates Hot 6-6 Typewriter Too Noisy 6-6 Print Quality Problems Characters Do Not Print 6-7 6-7 Characters Print Too Lightly Typing Problems Line Spacing Aligns Incorrectly Paper Feeds Incorrectly Wrong Characters Print or Characters Space Incorrectly Wrong Character Spacing or Breaks in Underline 6-7 8.8 6-8 6-8 6-8 6-8 610 Eeeper and Light Signals Beeper Signals Three Times Wail until the typewriter stops printing, then continue typing. You were typing faster than the typewr€ter could accept your typing. Beeper Signals Three Times and Line Space Lights Blink Continuously If the beeper signals three times and the Line Space lights blink continuously when you turn the typewriter on; • The batteries are €nstalled incorrectly, or • No batteries acre installed, or • The batteries are weak, or • The batteries are dead, Check the following wh€le the typewriter is on: 1. Make sure the battery holder wire plug is connected. (See page 7-12 In the Reference section.) 2. Look it the batteries for correct installation. • It the batteries are installed correctly, the batteries may be weak or dead. 3. Replace all three weak or dead batteries. • Do not turn the typewriter off while replacing the old batteries. if you turn the typewriter off without batteries installed, margins, tabs, and storage will be lost. Refer to "Batteries" on page 7-12 in the Reference section for correct installation, type and size of batteries. Beeper Signals Three Times and the Store Light Blinks DO not continue to type. You must create more space it you want to store the remainder of the job. See "Storage Full Warning" on page 3-27. However, if you do not want to continue to store, press Store. I 1-2 Operator's Guide Problem Determination 44