IBM 68666AU User Guide - Page 100

7. Update the computer configuration. See "Updating the computer configuration" on page 84. Note: If an error message related to the chassis-intrusion detector appears after you restart your computer, you must type the administrator password. For more information, see "Using passwords" on page 45. Completing the installation After working with options, you need to reinstall any removed parts, replace the cover, and reconnect cables, such as power cords and monitor cables. Also, depending on the option installed, you might need to update information in the Configuration/Setup Utility program or install device drivers. For instructions on how to install device drivers, see the instructions that come with your option. Some device drivers are included on the Device Driver and IBM Enhanced Diagnostics CD that comes with your computer. Updating the computer configuration Important The configuration information in this section applies to installing options. For more information on using the Configuration/Setup Utility program, see the Chapter 4, "Using the Configuration/Setup Utility program" on page 39. After adding options, you must update the configuration settings. In most cases, system programs perform this configuration automatically. If the settings are not updated automatically, you can use the Configuration/Setup Utility program to reconfigure the appropriate settings. In either case, you must save the settings before exiting from the Configuration/Setup Utility program. For example, when you start your computer after adding most internal hard disk drives, the settings might be updated. If the settings are not updated, use the Configuration/Setup Utility program to make and save those changes. Note: For more information on error messages from resource conflicts, see Chapter 6, "Troubleshooting" on page 87. 84 IntelliStation Z Pro User Guide