IBM 86625RY Hardware Maintenance Manual - Page 109
General options, Enabling or disabling the alarm, Resetting the alarm
UPC - 087944501855
View all IBM 86625RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
4. Type in either the Host Name or the TCP/IP Address of the system, or select it from the pull-down list. Note If the server was started on any port other than the default (1087), after the Host Name or TCP/IP Address that you just entered, type in a colon and the correct port number for the configuration (for example: ServeRAID:1088). 5. Select Connect to initiate a connection with the remote system. General options: When you select General Options from the Options pull-down menu, a screen similar to the following appears. You can use this screen to: Enable or Disable the alarm Reset the alarm Set the polling options Enabling or disabling the alarm: The alarm alerts you to a failure in the system. It sounds if any of the following conditions occur: A DDD hard disk drive is found. A Predictive Failure Analysis (PFA) error occurs. A ServeRAID adapter or controller is not responding. To enable or disable the alarm, select the box for Disable Alarm on the General Options screen. Placing a check in the check box disables the alarm; removing the check enables the alarm. Resetting the alarm: STOP Resetting the alarm turns off the alarm for the current failure without disabling the feature. Netfinity 5500 M20 - Type 8662 101