IBM 86625RY Hardware Maintenance Manual - Page 233

Installing devices in the NetBAY3 Use the following information for installing devices in the NetBAY3. Note The illustrations in this section do not show the server on top of the NetBAY3; however, you do not need to remove the NetBAY3 to install devices. General considerations: You can install three types of devices in the NetBAY3: Devices, such as the IBM EXP10, that sit on side rails Cantilevered devices, such as a power distribution unit (PDU), that are screwed to the front or rear of the NetBAY3 Devices that sit on the NetBAY3 base plate Notes 1. To allow the NetBAY3 front bezel to close, devices with handles must not protrude out more than 56 cm (2.2 in.). The following illustration of the front bezel top-view cross section shows the clearances. 2. All device cables must exit from the rear of the NetBAY3. 56 mm (2.2 in.) 30 mm (1.2 in.) Removing the rear panel: Note Do not remove the rear panel if you are not installing a device in the NetBAY3. 1. Remove the NetBAY3 rear panel. a. Remove the four screws. b. Lift the rear panel off. Netfinity 5500 M20 - Type 8662 225