IBM 86625RY Hardware Maintenance Manual - Page 50

6. Select the adapter pair you want and then select OK. Note that the integrated Ethernet controller is located at PCI primary bus 0, slot 14. 7. Select Close to exit from the Network setup. When you restart the server, the failover function will be in effect. If a failover occurs, a message is written to the Windows NT Event Viewer log. If the DMI instrumentation code for the integrated Ethernet controller is active (PCNET.EXE was run), a pop-up message is generated also. IntraNetWare 1. Add the redundant NIC adapter according to the instructions provided with the adapter and in "Adapters" on page 161. 2. Load the device driver by using the following command: LOAD d:\path\PCNTNW.LAN PRIMARY=x SECONDARY=y where d and path are the drive and path where the driver is located, and x and y are the PCI slot numbers where the redundant pair is located. The slot number associated with the integrated Ethernet controller can vary depending upon the configuration of the server. To determine the slot number, load the driver with no parameters. The driver will display the available slot numbers. The slot number that is greater than 10000 will be the slot number of integrated Ethernet controller. When the slot number of the integrated Ethernet controller is determined, reload the driver with the appropriate parameters. 3. When the driver is loaded, bind it to a protocol stack. The failover function is now enabled. If a failover occurs: A message is generated to the operating system console. The custom counters for the device driver contains variables that define the state of the failover function and the location of the redundant pair. You can use the NetWare Monitor to view the custom counters. 42 Netfinity Server HMM