IBM 86625RY Hardware Maintenance Manual - Page 176
Incomplete insertion might cause damage to, seated in the system board connector.
UPC - 087944501855
View all IBM 86625RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
b. Lift the tab 1 covering the top of the expansion-slot cover 3 and remove expansion-slot cover from the server. Store it in a safe place for future use. Attention Expansion-slot covers must be installed on all vacant slots. This maintains the electromagnetic emissions characteristics of the system and ensures proper cooling of system components. 5. Refer to the documentation that comes with the adapter for any cabling instructions. It might be easier for you to route any cables before you install the adapter. 6. Remove the adapter from the static-protective package. Note Avoid touching the components and gold-edge connectors on the adapter. 7. Place the adapter, component-side up, on a flat, static-protective surface. 8. Install the adapter 7 : a. Carefully grasp the adapter 7 by its top edge or upper corners, and align it with the expansion slot on the system board. b. Press the adapter firmly into the expansion slot. Attention When you install an adapter in the server, be sure that it is completely and correctly seated in the system board connector. Incomplete insertion might cause damage to the system board or the adapter. c. Lower the tab 1 over the tab on the top corner of adapter. Rotate the orange adapter retention latch 2 clockwise until it snaps into place. Note The expansion slot also has an adapter retention latch 8 at the end of the slot toward the middle of the server. To remove the adapter, you need to push this adapter retention latch 8 away from the adapter until the top edge of the adapter is past the latch. 9. Connect any needed cables to the adapter. 10. Enable the PCI slot from the operating system. (Refer to the documentation that comes with the operating system for information about enabling a 168 Netfinity Server HMM