IBM 86625RY Hardware Maintenance Manual - Page 284
Server door and trim bezels removal, NetBAY3 bezel and pull it away from the pedestal.
UPC - 087944501855
View all IBM 86625RY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 284 highlights
Server door and trim bezels removal Refer to the following illustration while you perform the steps in this procedure. 1 Server door 2 NetBAY3 bezel 3 Media-bay trim bezel To remove the server door: 1. Unlock and open the server door 1 . 2. Lift the server door up and off its hinges. Store the door in a safe place. To remove the NetBAY3 bezel (tower models only): 1. Unlock the NetBAY3 bezel 2 . 2. With your fingers on the ribbed area on the right side of the NetBAY3 bezel 2 , grasp the right side of the NetBAY3 bezel and pull it away from the pedestal. 3. Unhook the left side of the bezel from the server. Store the bezel in a safe place. To remove the media-bay trim bezel: 1. Release the two tabs at the bottom edge of the bezel 3 and pull the bottom of the bezel slightly away from the server. 2. Pull the bezel down to release the two tabs at the top edge of the bezel. Store the bezel in a safe place. 276 Netfinity Server HMM