IBM 86802SY Hardware Maintenance Manual - Page 133

Attention To ensure rack stability, plan the installation of servers in the rack starting from the bottom. To attach the mounting hardware to the rack: 1. Remove the rack front door. Refer to the rack documentation for instructions. 2. Mark the positions of the slide-bracket assemblies, bezel brackets, and the cable-management arm on the rack: a. Position the installation template on the front mounting rails on the rack, aligning the holes. b. Mark the holes for the slide-bracket assemblies and bezel brackets. c. Move the template to the same U level at the rear of the server and mark the locations for the slide-bracket assemblies and cable-management arm. d. Install the six cage nuts at the locations marked on the mounting rails for the cable-management arm and bezel brackets. 3. Attach a slide-bracket assembly to the front of the rack: a. Position the slide-bracket assembly behind the mounting rail so that the slides will extend out from the front of the rack. Netfinity 7000-M10 - Type 8680 125