IBM 86802SY Hardware Maintenance Manual - Page 33

The Configuration/Setup Utility Program For most configurations, the server will operate using the default system settings. You need to change the settings only to resolve configuration conflicts or to enable or change device functions (for example, defining diskette types, and so on). When you want or need to change the default settings, the Configuration/Setup Utility program provides a convenient way to display and change the settings. After you run and exit from the Configuration/Setup Utility program, configuration information is stored in electrically erasable programmable read-only memory (EEPROM). While the server is off, the configuration information remains available for the next system startup. Always run the Configuration/Setup Utility program if you add, remove, or relocate any hardware option, or if you receive an error message instructing you to do so. Review this information the information that comes with the option before making changes. Also, record the current settings before making any changes. To start the Configuration/Setup Utility program: 1. Turn on the server and watch the screen. 2. When the message Press F1 for Configuration/Setup appears, press F1. Note If you enter the power-on password and an administrator (supervisor-level) password is also set, a limited version of the menu appears. To see the full menu, you must restart the server and enter the administrator password when you are prompted to enter a password. See "System Security" on page 28 for additional information. The Configuration/Setup Utility main menu appears. For information about the menu, see "Using the Configuration/Setup Utility Main Menu" on page 26. Note When the message Press F2 for Diagnostics appears, press F2 to run the diagnostics programs. For information about running the diagnostics programs, see "Diagnostic Programs" on page 12. Netfinity 7000-M10 - Type 8680 25