IBM 86802SY Hardware Maintenance Manual - Page 159
Removing the Front Access Cover on Touch the static-protective package containing
![]() |
UPC - 087944496816
View all IBM 86802SY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Refer to this illustration while you perform the steps in this procedure. 1 Latches 2 Retaining clips 3 DIMM Before you begin: Read "Safety Information" on page 226. Read the documentation that comes with your option. To install a memory module: 1. Run the shutdown procedure for the operating system. Turn off the server and peripheral devices and disconnect all external cables and power cords (see "Preparing to Install Options" on page 160); then remove the front bezel (see "Removing the Front Bezel" on page 163), and the front access cover (see "Removing the Front Access Cover" on page 163). 2. Remove the memory board from the server: a. Pull the latches 1 so they rotate to a 90-degree angle from the memory board. b. Grasp the two latches and carefully pull the memory board from the server. c. Place the memory board connector-side up on a flat, static-protective surface. 3. Touch the static-protective package containing the memory-module kit to any unpainted metal surface on the server. Then, remove the memory module from the package. 4. Install the memory module: Attention: To avoid breaking the retaining clips or damaging the memory-module connectors, handle the clips gently. a. Turn the memory module (DIMM) 3 so that the pins align correctly with the connector. Netfinity 7000-M10 - Type 8680 151
![](/manual_guide/products/ibm-86803ru-hardware-maintenance-manual-dc70288/159.png)