IBM 86802SY Hardware Maintenance Manual - Page 147
Replacing a Drive in a Hot-Swap Bay, Identifying Problems through Status Indicators
![]() |
UPC - 087944496816
View all IBM 86802SY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 147 highlights
Refer to the following illustration while you perform the steps in this procedure. 1 Filler panel 2 Hot-swap hard disk drive 3 Drive tray handle (open position) To install a drive in a hot-swap bay: 1. Determine the bay in which you want to install the drive. 2. Remove the filler panel 1 from the empty hot-swap bay by inserting your finger into the depression at the left side of the filler panel and pulling it away from the server. 3. Install the hard disk drive 2 in the hot-swap bay: a. Ensure the tray handle 3 is open (that is, perpendicular to the drive). b. Align the drive/tray assembly so that it engages the guide rails in the bay. c. Gently push the drive assembly into the bay until the drive connects to the backplane. d. Push the tray handle to the right until it locks. 4. Check the hard disk drive status indicators to verify that the hard disk drives are operating properly. See "Identifying Problems through Status Indicators" on page 16 for details. Note If your server has a RAID adapter installed, refer to the RAID adapter documentation for details about configuration requirements. Replacing a Drive in a Hot-Swap Bay Note You do not have to turn off the server to remove a drive from a hot-swap bay. Netfinity 7000-M10 - Type 8680 139
![](/manual_guide/products/ibm-86803ru-hardware-maintenance-manual-dc70288/147.png)