IBM 86802SY Hardware Maintenance Manual - Page 98
Function Card Component Locations on To replace the battery
![]() |
UPC - 087944496816
View all IBM 86802SY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
To replace the battery: 1. Turn off the server and peripheral devices and disconnect all external cables and power cords (see "Preparing to Install Options" on page 160); then remove the top cover (see "Removing the Top Cover" on page 161). 2. Remove the I/O function card from the server: a. Refer to the following illustration while you perform the steps in this procedure. b. Disconnect the cables 1 from the I/O function card 2 . Note carefully where each cable is connected before you remove it. c. Remove the two screws 2 located on the metal connector plate inside the server. d. Carefully grasp the I/O function card by its top edge and pull the I/O function card out of the server. e. Place the I/O function card connector-side up on a flat, static-protective surface. 3. Locate the battery on the I/O function card (see "I/O Function Card Component Locations" on page 145). 90 Netfinity Server HMM
![](/manual_guide/products/ibm-86803ru-hardware-maintenance-manual-dc70288/98.png)