IBM 86802SY Hardware Maintenance Manual - Page 187
might cause damage to server components or, Incomplete insertion
UPC - 087944496816
View all IBM 86802SY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 187 highlights
4. Remove the expansion-slot cover 3 : a. Rotate the adapter retention latch 2 . b. Lift the tab 1 covering the top of the expansion-slot cover 3 and remove the expansion-slot cover from the server. Store it in a safe place for future use. Attention: Expansion-slot covers must be installed on all vacant slots. This maintains the electromagnetic-emissions characteristics of the system and ensures proper cooling of system components. 5. Refer to the documentation that comes with your adapter for any cabling instructions. It might be easier for you to route any cables before you install the adapter. 6. Remove the adapter from the static-protective package. Note Avoid touching the components and gold-edge connectors on the adapter. 7. Place the adapter, component-side up, on a flat, static-protective surface. 8. Set any jumpers or switches as described by the adapter manufacturer. 9. Install the adapter: a. Carefully grasp the adapter 7 by its top edge or upper corners, and align it with the expansion slot on the I/O board. b. Press the adapter firmly into the expansion slot. Attention: When you install an adapter in the server, be sure that it is completely and correctly seated in the connector. Incomplete insertion might cause damage to server components or the adapter. c. Lower the tab 1 over the adapter. Rotate the adapter retention latch 2 until it snaps in place. Note The expansion slot also has an adapter retention latch 8 at the opposite end of the slot. To remove the adapter, push the adapter retention latch away from the adapter until the top edge of the adapter is past the latch. 10. Connect any cables to the adapter. 11. Enable the PCI slot from your operating system. Make sure the Power On light 5 for the PCI slot is on. 12. If you have other options to install or remove, do so now; otherwise, go to "Completing the Installation" on page 97. Netfinity 7000-M10 - Type 8680 179