IBM 86802SY Hardware Maintenance Manual - Page 99
I/O board., matching openings on the server back panel.
UPC - 087944496816
View all IBM 86802SY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 99 highlights
4. Remove the battery: a. Use one finger to lift the battery clip over the battery. b. Use one finger to slightly slide the battery toward the rear of the I/O function card. The spring mechanism behind the battery will push it out toward you as you slide it forward. c. Use your thumb and index finger to pull the battery from under the battery clip. d. Ensure that the battery clip is touching the base of the battery socket by pressing gently on the clip. 5. Insert the new battery: a. Tilt the battery so that you can insert it into the front of the socket, under the battery clip. b. As you slide it under the battery clip, press the battery down into the socket. 6. Install the I/O function card: a. Carefully grasp the I/O function card by its top edge, and insert the tabs 3 on the bottom edge of the metal connector plate in the matching openings on the server back panel. b. Align the I/O function card with the guide on the opposite end of the adapter and the slot on the I/O board. c. Press the I/O function card firmly into the slot. Attention: When you install the I/O function card in the server, be sure that it is completely and correctly seated. Incomplete insertion might cause damage to server components. d. Insert the two screws you removed in step 2c on page 90. e. Connect the cables you disconnected in step 2b on page 90. Netfinity 7000-M10 - Type 8680 91