IBM 887022X Maintenance Manual - Page 200
symptoms, Light, errors, Level, light
UPC - 000435151957
View all IBM 887022X manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 200 highlights
Note: See Chapter 8, "Parts listing, Type 8870," on page 249 to determine which components are replaceable by the customer, and which components should be replaced by an IBM field service technician. Beep/symptom FRU/action Two long and two short beeps 1. I/O board 2. Center plane No beep symptoms Note: See Chapter 8, "Parts listing, Type 8870," on page 249 to determine which components are replaceable by the customer, and which components should be replaced by an IBM field service technician. No beep symptom FRU/action No beep and the system operates correctly. Light path card No beeps occur after successfully completing POST (Power-On Status is disabled.) 1. Run Configuration/Setup, set the Start Options Power-On Status to enable. 2. Light Path card. 3. SMP board. No ac power (Power supply ac LED is off) 1. Check the power cord. 2. Power supply (if two are installed, swap them to determine if one is defective.) 3. Top power board No beep and no video See "Undetermined problems" on page 246. System will not power-up (Power supply ac LED is on) 1. See "Power LED errors" on page 240. 2. Microprocessor installation sequence (see "Installing and replacing a microprocessor" on page 116). Light path LED errors Before replacing any FRU: 1. Observe LEDs on boards. 2. View System-Error log. Note: For 16-way configuration, each chassis must be powered on as a standalone server to observe the LEDs for the boards of that chassis. Level 1 light path The level 1 light path consists of the system-error LED on the front panel (see "Light path diagnostics" on page 65). 190 xSeries 445 Type 8870: Hardware Maintenance Manual and Troubleshooting Guide