IBM DTTA-351010 Hard Drive Specifications - Page 50
For Disabling Auto Spin with Default Logical Head 16
View all IBM DTTA-351010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
6.3.4.4 For Disabling Auto Spin with Default Logical Head 16 I G E C A H F D B I G E C A H F D B I G E C A H F D B I G E C A H F D B DEVICE 0 DEVICE 1 CABLE SELECT DEVICE 0 Forcing DEVICE 1 PRESENT Figure 34. Jumper Block Setting Position Notes: 1. All other setting patterns are reserved. Do not make other setting. 2. When CABLE SELECT is specified, AT interface signal #28 CSEL is referred to determin the drive address as follows: When CSEL is grounded or at a low level, the drive address is 0 (Device0). When CSEL is open or at a high level, the drive address is 1 (Device1). 42 OEM Specifications for DTTA-3xxxxx
6.3.4.4
For Disabling Auto Spin with Default Logical Head 16
I
G
E
C
A
DEVICE 0
H
F
D
B
I
G
E
C
A
DEVICE 1
H
F
D
B
I
G
E
C
A
CABLE SELECT
H
F
D
B
I
G
E
C
A
DEVICE 0
Forcing DEVICE 1 PRESENT
H
F
D
B
Figure 34. Jumper Block Setting Position
Notes:
1. All other setting patterns are reserved. Do not make other setting.
2. When CABLE SELECT is specified, AT interface signal #28 CSEL is referred to determin the drive
address as follows:
When CSEL is grounded or at a low level, the drive address is 0 (Device0).
When CSEL is open or at a high level, the drive address is 1 (Device1).
42
OEM Specifications for DTTA-3xxxxx