IBM DTTA-351010 Hard Drive Specifications - Page 52
DC Power Requirements
View all IBM DTTA-351010 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
6.5 DC Power Requirements Connection to the product should be made in isolated secondary circuits (SELV). The following voltage specification is applied at the power connector of the drive. Damage to the file electronics may result if the power supply cable is connected or disconnected while power is being applied to the file (Hot plug/unplug is not allowed). There is no special power on/off sequencing required. Figure 36. Input Voltage + 5 Volts Supply + 1 2 Volts Supply During run and spin up 5V + / - 5 % DTTA-35xxxx 12V + 1 0 % , - 8 % DTTA-37xxxx 12V + / - 5 % Absolute max voltage 7V 15V Figure 37. Power Supply Current of DTTA-37xxxx (All values in Amps.) +5Volts Pop Mean Std.Dev Idle Average 0.29 0.02 Idle ripple (peak-to-peak) 0.25 0.04 Seek peak 0.55 0.02 Seek average (*1) 0.33 0.02 Start up (max) 0.7 0.02 RND R/W peak 0.8 0.15 R N D R/W average (*2) 0.42 0.15 Standby/Sleep average 0.165 0.01 +12Volts Pop Mean Std.Dev 0.45 0.1 0.7 0.15 1.7 0.2 0.7 0.1 2 0.1 0.75 0.1 0.65 0.1 0.0045 0.001 Total (W) 6.9 10.1 9.9 0.9 Figure 38. Power Supply Current of DTTA-351680/351350/351290 (All values in Amps.) +5Volts Pop Mean Std.Dev +12Volts Pop Mean Std.Dev Idle Average 0.29 0.02 0.29 0.1 Idle ripple (peak-to-peak) 0.25 0.04 0.6 0.15 Seek peak 0.55 0.02 1.6 0.2 Seek average (*1) 0.33 0.02 0.6 0.1 Start up (max) 0.7 0.02 2 0.1 RND R/W peak 0.8 0.15 0.65 0.1 R N D R/W average (*2) 0.42 0.15 0.55 0.1 Standby/Sleep average 0.165 0.01 0.0045 0.001 Total (W) 4.9 8.9 8.7 0.9 44 OEM Specifications for DTTA-3xxxxx