Icom IC-M802 Instruction Manual - Page 18
Receive And Transmit
View all Icom IC-M802 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
4 RECEIVE AND TRANSMIT I Basic voice transmit and receive q Check the following in advance. ➥ Microphone is connected. ➥ No "SQL" indication. • If "SQL" appears, push [F] then [2 SQL] to turn the squelch OFF. ➥ No " SP " indication. • If " SP " appears, push [F] then [4 SP×] to activate the speaker. ➥ The clarity function is not activated. • If the clarity function is activated, push [F] then [RX CLAR] to turn the function OFF. [4 SP×] [2 SQL] Microphone connector [F] [RX CLAR] w Rotate [GRP] and [CH] to select the desired channel to be received. • When receiving a signal, the S-meter shows the signal strength. e Adjust [VOL] to the desired audio level when receiving a signal. r Push [MODE SET] to select the desired operating mode. t Push [TUNE THRU] to tune the antenna tuner, if connected. • Skip this operation when the "AUTO TUNE" is set to ON in initial set mode (p. 50). y To transmit on the channel, push and hold the PTT switch on the microphone. • "TUNE" blinks for 1 to 2 sec. for the first transmission on a channel when the automatic tuning function is activated. u Speak into the microphone at your normal voice level. • The RF meter shows the output power according to your voice level. • If "SWR" appears, check your antenna system. i Release the PTT switch to return to receive. I Functions for transmit D Transmit frequency check When "DUP" appears in the display such as for a ship-to-ship channel, the transmit frequency differs from the receive frequency. In such cases, the transmit frequency should be monitored before transmitting to prevent interference to other stations. ➥ Push [F] then push and hold [TX TXF] to monitor the transmit frequency. [F] [TX TXF] • "TX" blinks and the display shows the transmit frequency. D Transmit power selection The transceiver has 3 selectable power output levels. High power allows longer distance communications and low power reduces power consumption. q Push [F] first. • " " appears. w Push one of [7 Lo], [8 Mid] or [9 Hi] to select low, middle or high output power levels, respectively. • The display shows the selected output power level for approx. 2 sec., then returns to the previous indication. [7 Lo] [8 Mid] [9 Hi] [F] 10