Icom IC-M802 Instruction Manual - Page 24

6 DSC PREPARATION I Position and time programming When no position and the UTC (Universal Time Coordinated) time data in NMEA0183 ver. 3.01 format, such as from a GPS receiver, etc., is applied to [GPS] connector, your position and the UTC time should be input for DSC operation. IMPORTANT! The manually programmed position and the UTC time settings will be cleared once the power is turned OFF. They are never renewed during the voyage when the position is set manually. q While pushing and holding [MODE SET] push [POWER] to enter initial set mode. • Turn the power OFF in advance. [MODE SET] [POWER] w Rotate [GRP] to select the "GPS DISPLAY" then rotate [CH] to select the desired position indication type from simple and detail. *** SET MODE *** ÇÇ S I M P L E DETAIL ITEM SEL e Rotate [GRP] to select the "OFFSET TIME" then rotate [CH] to set the time difference between local and the UTC times within -12 to +12 hours in 10 minute steps. *** SET MODE *** ✔When a position and the UTC time data (NMEA0183 ver. 3.01 format) is applied to [GPS], the following steps are not necessary. t Push [DSC] to select DSC watch mode. y Push [MODE SET] to enter the DSC menu. • DSC menu is displayed as below. u Rotate [CH] to select "Position," then push [ENT]. ******* DSC MENU ******* -------- Select -------- ÇPosition Individual Group All ships Position REQ Distress SEL OK i Enter your position and the UTC time via the keypad, then push [ENT] • Push [3 SCAN] for the 'East,' [9 Hi] for the 'West,' [6 RF-G] for the 'North' and [7 Lo] for the 'South' setting. • Degrees and minutes digits can only be entered even when "DETAIL" is selected for the position indication in step w- the seconds digits show "0" only. • Rotate [CH] to move the cursor. ******* Position Position & time ---- Latitude 34 34'N Longitude 135 34'E UTC 12:34 ITEM SEL r Turn the power OFF once, then ON again to exit quick set mode. Null OK o Push [ENT] to program the position and time. • Return to the "DSC MENU" indication as in step u. !0 Push [MODE SET] to exit the DSC menu. • Rotate [CH] to select "Exit" then push [ENT] also exits set mode. • "MNL" appears instead of "GPS." • Simple position indication • Detail position indication RX 12.345.0 MNL SP Exit J3E Lat 34 34'N Lon135 34'E 12:34 RX 12.345.0 J3E MNL 34 34.000N SP 135 34.000E 12:34 Exit 16