Icom IC-M802 Instruction Manual - Page 41
The 9-digit identity
View all Icom IC-M802 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
7 CALL PROCEDURE !0 The calling stand-by screen is displayed as follows, verify the calling condition then push and hold [CANCEL/CALL] for 1 sec. to transmit the routine call. • Push and hold [ENT] for 1 sec. to store the calling condition into the TX memory described in pages 23 and 43, if desired. ****** Individual ****** --------- Call --------- Category:Routine To:987654321 Traffic:J3E TX 4567.0kHz RX 4567.0kHz Call Freq:TX 2345.0kHz RX 2345.0kHz Call Write-Menu !3 Announce the following message to stations. - The 9-digit identity (or call sign or other identification) of the station which you want to call. - "This is ..... (your ship name)." - The 9-digit identity OR call sign (or other identification of the ship). When no acknowledgement is received: q Wait for 5 min., then call again on the same or a different frequency. w If no acknowledgement is received after a 2nd call, wait for at least 15 min. before repeating the call. !1 After sending the call, the transceiver waits for an acknowledgement. Individual < Wait for ACK > RX J2B GPS Lat 34 34'N SP Lon135 34'E 12:34 Exit !2 When receiving an acknowledgement, the display 7 shows the received ID code, or the called station name. • Push [FREQ/CH]; - to select the traffic frequency if the called station is able to comply to the call. - to return to DSC watch mode when unable. * Individual ACK * * IC-M802 * * Able to comply * Exit * Individual ACK * * IC-M802 * * Unable to comply * * Operator unavailable * Exit When the called station is unable to comply to the call, the reason may be displayed. 33