Insignia NS-19LD120A13 User Manual (English) - Page 16
Connecting an antenna or cable TV no box, Connecting a DVD or Blu-ray player
View all Insignia NS-19LD120A13 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
NS-19LD120A13 Insignia 19" LCD TV/DVD Combo Connecting an antenna or cable TV (no box) To connect an antenna or cable TV (no box): 1 Make sure that your TV/DVD combo's power cord is unplugged, and all connected equipment is turned off. 2 Connect a coaxial cable to the ANT/CABLE IN jack on the side of your TV/DVD combo and to the antenna or cable TV wall jack. Antenna or cable TV (no box) Connecting a DVD or Blu-ray player Using HDMI (best) To connect a DVD or Blu-ray player using HDMI: 1 Make sure that your TV/DVD combo's power cord is unplugged and the DVD or Blu-ray player is turned off. 2 Connect an HDMI cable (not provided) to the HDMI jack on the side of your TV/DVD combo and to the HDMI OUT jack on the DVD or Blu-ray player. DVD or Blu-ray player Coaxial cable HDMI cable Side of TV 3 Plug your TV/DVD combo's power cord into a power outlet, then turn on your TV/DVD combo. 4 Go through the Setup Wizard on page 19. Notes • • • Use a coaxial cable to eliminate interference and noise from radio waves. Do not bundle the coaxial cable with the power cord or other cables. If the antenna is not installed correctly, contact qualified service personnel to correct the problem. If the signal level for a channel is weak, the picture may be distorted. Adjust the antenna or use a highly directional outdoor or set-top antenna with a built-in amplifier. If the picture quality is good on some channels and poor on others, the problem may be caused by a poor or weak signal from the broadcaster or cable TV provider. If you connect to cable or satellite TV without a set-top box and experience poor picture quality, you may need to install a set-top box to improve signal reception and picture quality. Contact your cable or satellite TV provider about upgrading to a set-top box. Many high-definition (HD) channels upscale standard-definition (SD) content. The picture displayed on your TV/DVD combo is still displayed as SD, thus the picture quality will not be as clear or crisp as it would be if the content was originally recorded in HD. Side of TV 3 Plug your TV/DVD combo's power cord into a power outlet, then turn on your TV/DVD combo. 4 Turn on the DVD or Blu-ray player, then set it to the correct output mode. For more information, see the documentation that came with the player. 5 Press INPUT to open the Input Source list. 6 Press INPUT repeatedly or press S or T to highlight HDMI, then press ENTER/ . 12 www.insigniaproducts.com