Intel D848PMB Technical Product Specification - Page 65
BIOS Setup Configuration Jumper Block
View all Intel D848PMB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Technical Reference Table 35 describes the two configurations of this connector/jumper block. CAUTION Do not place jumpers on this block in any configuration other than the one described in Table 35. Other jumper configurations are not supported and could damage the Desktop Board. Table 35. Front Panel Audio Connector/Jumper Block Jumper Setting 1 2 3 4 5 6 7 9 10 1 and 2 5 and 6 9 and 10 Configuration Audio line out signals are routed to the back panel audio line out connector. The back panel audio line out connector is shown in Figure 10 on page 51. 1 2 3 4 5 6 7 9 10 No jumpers installed Table 19 on page 54 lists the names of the signals available on this connector when no jumpers are installed. # INTEGRATOR'S NOTE When the jumpers are removed and this connector is used for front panel audio, the back panel audio line out and mic in connectors are disabled. 2.9.2 BIOS Setup Configuration Jumper Block The 3-pin jumper block determines the BIOS Setup program's mode. Table 36 describes the jumper settings for the three modes: normal, configure, and recovery. When the jumper is set to configure mode and the computer is powered-up, the BIOS compares the processor version and the microcode version in the BIOS and reports if the two match. Table 36. BIOS Setup Configuration Jumper Settings Function/Mode Normal Jumper Setting 1-2 1 3 Configuration The BIOS uses current configuration information and passwords for booting. Configure 2-3 1 After the POST runs, Setup runs automatically. The 3 maintenance menu is displayed. Recovery None 1 The BIOS attempts to recover the BIOS configuration. A 3 recovery diskette is required. 65