Intermec CK3R CK3R and CK3X Mobile Computer User Manual - Page 72
Con x Security with Funk Security
![]() |
View all Intermec CK3R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Chapter 3 - Configure the Computer 2 Select Communications > 802.11 Radio > Funk Security. 3 Select a Funk security profile to configure. 4 Enter the SSID. 5 For Association, select WPA or WPA2. The default encryption is TKIP or AES, respectively. 6 For 8021x, select None. 7 For Pre-Shared Key, enter the pre-shared key or passphrase: • Enter the pre-shared key (0x followed by 32 hexadecimal pairs) for your access point. • Enter the passphrase (8 to 63 ASCII characters) for your authenticator. The computer internally converts the passphrase to a pre-shared key. 8 Tap OK. Configure 802.1x Security with Funk Security Before you set 802.1x-WEP security with Funk security, you need to enable the radio on your computer and set the date. To use TLS protocol, you also need to load a user and root certificate. Intermec recommends that you use WPA2-802.1x instead of 802.1x-WEP if possible. 1 Start Intermec Settings. 2 Select Communications > 802.11 Radio > Funk Security. 3 Select a Funk security profile to configure. 4 Enter the SSID. 5 For Association, select Open. 6 For Encryption, select WEP. 7 For 8021x, select TTLS, PEAP, or TLS. 8 If you selected TTLS or PEAP: a For Prompt for Credentials, select Enter credentials now. b Enter a User Name and a User Password. 60 CK3R and CK3X Mobile Comptuer User Manual
![](/manual_guide/products/intermec-ck3x-ck3r-ck3x-mobile-user-manual-bd6dee7/72.png)