Intermec PB31 PB21 and PB31 Mobile Receipt Printer User Guide - Page 52
is a value between 8 and 64 characters., Send one of these WPA/WPA2 ON commands to set up WPA
View all Intermec PB31 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Chapter 2 - Configuring the PB21 and PB31 To configure the printer to use WPA-PSK or WPA2-PSK mode 1 Send these commands to login as an admin and set the SSID: run"su-p pass admin" setup write "wlan","uart1:" setup "wlan","SSID","xxxxx" where xxxxx can be from 0 to 32 alphanumeric characters. 2 Send one of these WPA/WPA2 ON commands to turn on WPA or WPA2 authentication. Send the WPA-PSK or WPA2-PSK command to set a pre-shared key: setup "wlan","WPA","ON" setup "wlan","WPA2","ON" setup "wlan","WPA_PSK","xxxxxxxxxx" setup "wlan","ACTIVE","1" setup write "wlan","uart1:" where xxxxxxxxxx is a value between 8 and 64 characters. To configure the printer to use WPA or WPA2 Enterprise mode 1 Send these commands to login as an admin and set the SSID: run"su-p pass admin" setup write "wlan","uart1:" setup "wlan","SSID","xxxxx" where xxxxx can be from 0 to 32 alphanumeric characters. 2 Send one of these WPA/WPA2 ON commands to set up WPA802.1x or WPA2-802.1x authentication. You should also send the WPA_PSK command that does not contain a value: setup "wlan","WPA","ON" setup "wlan","WPA2","ON" setup "wlan","WPA_PSK","" setup write "wlan","uart1:" 3 To view the 802.1x values, send this command: setup write "8021x","uart1:" 40 PB21 and PB31 Mobile Receipt Printer User Guide