Intermec PB32 PB22 and PB32 Mobile Label and Receipt Printer User Guide - Page 54
To con the printer to use WPA or WPA2 Enterprise mode, To view the 802.1x values
View all Intermec PB32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Chapter 2 - Configuring the PB22 and PB32 2 Send one of these WPA/WPA2 ON commands to turn on WPA or WPA2 authentication. Send the WPA-PSK or WPA2-PSK command to set a pre-shared key: setup "wlan","WPA","ON" setup "wlan","WPA2","ON" setup "wlan","WPA_PSK","xxxxxxxxxx" setup "wlan","ACTIVE","1" setup write "wlan","uart1:" where xxxxxxxxxx is a value between 8 and 64 characters. To configure the printer to use WPA or WPA2 Enterprise mode 1 Send these commands to login as an admin and set the SSID: run"su-p pass admin" setup write "wlan","uart1:" setup "wlan","SSID","xxxxx" where xxxxx can be from 0 to 32 alphanumeric characters. 2 Send one of these WPA/WPA2 ON commands to set up WPA802.1x or WPA2-802.1x authentication. You should also send the WPA_PSK command that does not contain a value: setup "wlan","WPA","ON" setup "wlan","WPA2","ON" setup "wlan","WPA_PSK","" setup write "wlan","uart1:" 3 To view the 802.1x values, send this command: setup write "8021x","uart1:" 4 Send these commands to configure the EAP_TYPE: setup "8021x","EAP_TYPE","xxxx" where xxxx can be OFF, LEAP, PEAP, or TTLS. setup "8021x",".EAP_USER","xxxx" setup "8021x","EAP_PASS","xxxx" where xxxx is the unique username and the unique password for this protocol. 5 If you are using TTLS, you may need to send this command to set the TTLS outer name: setup "8021x","TTLS_USER","xxxx" where xxxx is the outer name. 42 PB22 and PB32 Mobile Label and Receipt Printer User Guide