Kenmore 4602 Use and Care Guide - Page 10

Water Filter, Certifications - ratings

Page 10 highlights

• Has the ice melted around the auger (metal spiral) in the ice bin? Empty the ice container. Use warm water to melt the ice if necessary. Cut Hazard Use a sturdy glass when dispensing ice. Failure to do so can resuR in cuts. Is the ice dispenser stalling while dispensing "crushed" ice? Change the ice button from "crushed" to "cubed." If cubed ice dispenses correctly, depress the button for "crushed" ice and begin dispensing again. Has the dispenser lever been held in too long? Ice will stop dispensing when the arm is held in too long. Wait 3 minutes for dispenser motor to reset before using again. The water dispenser will not operate properly Check the following: • Is the freezer door closed completely? • Is the water shutoff valve not turned on, incorrectly installed or clogged? • Is the water line connected at the source? • Is there a kink in the home water source line? • Has the water system not filled? The water system needs to be filled the first time it is used. Is the refrigerator connected to a cold water line with water pressure of at least 30 psi (207 kPa)? The water pressure to the home determines the flow from the dispenser. Is there a water filter installed on the refrigerator? The filter may be clogged or incorrectly installed. Is a reverse osmosis water filtration system connected to your cold water supply? See "Water Supply Requirements" in either the Installation Instructions or the Use and Care Guide. Water is leaking from the dispenser Check the following: • Is the glass not being held under the dispenser long enough? • Has the water system been flushed since installation or changing filters? The dispenser water is not cool enough NOTE: Water from the dispenser is chilled to only 50°F (10°C). • Has the refrigerator been newly installed or a large amount of water recently dispensed? Allow 24 hours for the refrigerator to cool completely. • Has water not been recently dispensed? The first glass of water may not be cool. Discard the first glass of water. WATER FILTER CERTIFICATIONS State of Calitornia Department of Ilealth Services Water Treatment Device Certificate Number 04 - 1605 Date lsstled: January 5, 2(XN Date Revised: Decenaber I4, 2005 Trademark/Model Designation Kenmo_e Advanced Refftgerator Kenmore TI KB 1 Kenmore IJltimate T] KB t Kenmo_e Ultimate I1 T I KB l Fgter TI KB] Replacement TIRFKB1 TIRFKB1 T1RFKB1 T1RFKB1 Etenlent(s) Manufacturer: Sea, s, Roehuckan_lgkimpanv ........ C}sts A_4i_ Behz_ne Carbl;Nran Chlot:oge_zene Ch]ordt i_in 2,4-D DBCP o-Dich]oro6enze_e p-Dichlorobenzen_ 1,2-Dichloroet bane l,I-Dichloroethylene trans-1,2-Dichloroethylene 12-Dichloroprupane cis-1,3-Dichloropropylene Dinoseb Toluene 2 4,5-TP Silvex 1 r{bmmo_etic Acid 1,2,4-3_lcblorobe_zene 1.1. l -Tnchloroethane 3 rlchloromhyleue q ribalomethaues TriMs) Rated Service Capacity: l(gJgaI RatedSer',iceFto_: 05gpm Do not use where s_stems certified water is micr obiologically unsal_ or with water of unknowll quality, for cosst reduction may be used on disinfected waters that may contain except tbat filterable c}sts. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40

Has the ice melted around
the auger (metal spiral) in the
ice bin?
Empty the
ice
container.
Use warm water to melt the
ice if necessary.
Cut
Hazard
Use
a
sturdy
glass
when
dispensing
ice.
Failure
to do so
can
resuR
in cuts.
Is the ice dispenser
stalling while dispensing
"crushed"
ice?
Change
the
ice
button
from "crushed"
to "cubed."
If
cubed
ice dispenses
correctly,
depress
the button for
"crushed"
ice and begin dispensing
again.
Has the dispenser
lever been held in too long?
Ice will stop
dispensing
when the arm is held in too long. Wait 3 minutes
for dispenser
motor to reset before using
again.
The water
dispenser
will not operate
properly
Check
the
following:
Is the freezer door closed
completely?
Is the water shutoff
valve not turned
on, incorrectly
installed
or clogged?
Is the water
line connected
at the source?
Is there a kink in the home water source
line?
Has the water
system not filled?
The water system needs
to be filled the first time it is used.
Is the refrigerator
connected
to a cold water
line with
water
pressure
of at least 30 psi (207 kPa)? The water
pressure
to the home determines
the flow from the dispenser.
Is there a water
filter installed
on the refrigerator?
The
filter may be clogged
or incorrectly
installed.
Is
a
reverse osmosis water
filtration
system connected
to
your cold water
supply?
See "Water
Supply
Requirements"
in either the Installation
Instructions
or the Use and Care
Guide.
WATER FILTER
CERTIFICATIONS
State
of
Calitornia
Department
of
Ilealth
Services
Water
Treatment
Device
Certificate
Number
04 - 1605
Date
lsstled:
January
5, 2(XN
Date
Revised:
Decenaber
I4,
2005
Trademark/Model
Designation
Kenmo_e
Advanced
Refftgerator
Fgter
TI KB]
Kenmore
TI KB 1
Kenmore
IJltimate
T] KB t
Kenmo_e
Ultimate
I1 T I KB l
Manufacturer:
Sea, s, Roehuckan_lgkimpanv
........
Replacement
Etenlent(s)
TIRFKB1
TIRFKB1
T1RFKB1
T1RFKB1
C}sts
A_4i_
Behz_ne
Carbl;Nran
Chlot:oge_zene
Ch]ordti_in
2,4-D
DBCP
o-Dich]oro6enze_e
p-Dichlorobenzen_
1,2-Dichloroet
bane
l,I-Dichloroethylene
trans-1,2-Dichloroethylene
12-Dichloroprupane
cis-1,3-Dichloropropylene
Dinoseb
Toluene
2 4,5-TP
Silvex
1 r{bmmo_etic
Acid
1,2,4-3_lcblorobe_zene
1.1. l -Tnchloroethane
3 rlchloromhyleue
q ribalomethaues
TriMs)
Rated
Service
Capacity:
l(gJgaI
RatedSer',iceFto_:
05gpm
Do
not
use
where
water
is
micr
obiologically
unsal_
or
with
water
of
unknowll
quality,
except
tbat
s_stems
certified
for
cosst
reduction
may
be
used
on
disinfected
waters
that
may
contain
filterable
c}sts.
Water
is
leaking from the dispenser
Check
the
following:
Is the glass not being held under the dispenser
long enough?
Has the water system
been flushed
since installation
or
changing
filters?
The dispenser
water
is not
cool
enough
NOTE: Water from the dispenser
is chilled to only 50°F (10°C).
Has
the refrigerator
been
newly
installed
or a large
amount
of water
recently
dispensed?
Allow 24 hours for
the refrigerator
to cool completely.
Has water
not
been
recently
dispensed?
The first glass of
water may not be cool.
Discard
the first glass of water.
10